This will connect the reset system to the AVR device.Ĩ. Use another 2-wire cable to connect the PB5 pin (pin 6) on the PORTB header to the RST pin (pin 4) on the PORTE/AUX header. This will connect the clock system to the AVR device.ħ. Use one 2-wire cable to connect the PB3 pin (pin 4) on the PORTB header to the XT1 pin (pin 7) on the PORTE/AUX header. Mount jumper XTAL1 to route the oscillator signal to the device.Ħ. Mount jumper OSCSEL on pins 1 and 2 to select software-controlled clock.Ĥ. Place the ATTiny85 in the SCKT3400D1 socket and make sure all other sockets are empty!ģ. See the complete setup for ISP in the picture belowĢ. Place the ATTiny85-20PU in the SCKT3400D1 socketĬonnect the (12V) power supply and a (usb-to-)serial cable to connect the programmer to your computer to the RS232 CTRL port and power on the STK500
This is to connect the reset system to the AVR device. The second wire to connect the PB5 pin (pin 6) on the PORTB header to the RST pin (pin 4) on the PORTE / AUX header.This is to connect the clock system to the AVR device. One wire to connect the PB3 pin (pin 4) on the PORTB header to the XT1 pin (pin 7) on the PORTE / AUX header.This is the only way of programming that can be used after the ‘reset disable’ fuse is set on the ATTiny85.īefore being able to program the ATTiny85-20PU with the STK500 you need to add 2 jumper wires on the STK500:
#Attiny85 port pin pb5 serial
The other way of programming the ATTiny85 is High Voltage Serial Programming (HVSP). The first one is In-System Programming (ISP) The most common way of programming AVR’s. There are 2 ways of programming an ATTiny85 microcontroller using the Atmel AVR STK500 programmer.
#Attiny85 port pin pb5 how to
How to set up the Atmel AVR STK500 programmer for use with ATTiny85-20PU (or ATTiny45 / ATTiny25)
0 kommentar(er)
